System Board
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
When replacing the system board, make sure the following components are removed from the
defective system board and installed on the replacement system board:
●
Memory modules
●
Expansion cards
●
Heat sink
●
Processor
4.
Remove the baffle from the chassis
5.
Remove the fan from the chassis
6.
Rotate the drive cage to its upright position.
7.
Rotate the power supply to its full upright position.
8.
Disconnect all data and power cables from the system board.
9.
Disconnect the balance of the cables from the system board.
10.
Remove the eight screws that secure the system board to the chassis.
Figure 6-63
11.
Lift up the front of the system board, and then pull the system board forward, up, and out of the
chassis.
To install the system board, reverse the removal procedure.
(Computer Access Panel on page
(seeInstalling Additional Memory on page
(Expansion Cards on page
(Heat sink on page
83)
(Processor on page
84)
(Baffle on page
(Front Fan Assembly on page
Removing the system board
(Preparation for Disassembly on page
43).
51)
77).
35).
46)
78).
System Board
87