HP SignagePlayer mp8000r Maintenance And Service Manual page 78
Maintenance & service guide: hp signageplayer mp8000r and mp8000s
Hide thumbs
Also See for SignagePlayer mp8000r:
- Illustrated parts and service map (4 pages) ,
- Getting started manual (36 pages)
Table of Contents
Advertisement
3.
Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive toward
the front of the computer until it locks into place.
Figure 6-39
4.
Connect the appropriate drive cables:
a.
If installing a second hard drive, connect the power and data cables to the rear of the drive
and connect the other end of the data cable to the next available (unpopulated) SATA
connector on the system board by following the numbered sequence of the connectors.
b.
If installing a media card reader, connect the USB cable from the media card reader to the
USB connector on the system board labeled MEDIA. If the media card reader includes a
1394 port, connect the 1394 cable to the 1394 PCI card.
NOTE:
system board drive connectors.
5.
Replace the 5.25-inch drive.
6.
Replace the front bezel and access panel.
7.
If the computer was on a stand, replace the stand.
8.
Reconnect the power cord and turn on the computer.
9.
Lock any security devices that were disengaged when the access panel was removed.
68
Chapter 6 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
Installing a Drive into the 3.5-inch Drive Bay (Media Card Reader Shown)
Refer to
System Board Drive Connections on page 60
for an illustration of the
Advertisement
Table of Contents
