Management Commands - HP 12000 User Manual

Table 17 CLI Configuration Commands (continued)
Command
getStoragePoolSummary
addHost
listHostState
setHostState
setHostStateAll
listAccessMode
setAccessMode
setAlias
removeHost
addLunMap
listLunMap
deleteLunMap
g e t T a p e S e r i a l C o m p a t i b i l i t y M o d e
s e t T a p e S e r i a l C o m p a t i b i l i t y M o d e
getWwnnCompatibilityMode
setWwnnCompatibilityMode
1 <s> = string; <n> = number; <f> = filename

Management Commands

Use the CLI commands in
Change the account passwords
Manage cartridges
Restart the VLS device emulations
Save configuration settings
Restore configuration settings
142 CLI Command Set
1
Usage
Returns summary of storage pool information for all storage pools on the VLS.
Adds the specified host in the SAN list.
Lists the current host state for all hosts in the SAN list.
Sets the host state for specified host.
Sets the host state for all hosts in the SAN list to the state specified.
Lists the current host access mode for all enabled hosts in the system.
Sets the host access mode for all enabled hosts in the system.
Sets the alias for the hostname of the specified host.
Deletes the specified host from the SAN list.
Adds the specified device to the host.
Lists the host LUN map for specified device.
Deletes the specified device from the host.
Returns the compatibility mode for the virtual serial numbers.
Sets the compatibility mode for the virtual serial numbers. Upgrading to VLS firmware
version 3.3.0 cause the colons in serial numbers to change to periods.
-m <s> - Compatibility mode
Standard = default, keeps change of using periods instead of colons
Legacy = changes periods to back to colons
Returns the firmware version compatibility mode for the WWNNs.
Sets the firmware version compatibility mode for the WWNNs. Upgrading to VLS firmware
version 3.3.0 causes the WWNNs for the VLS host ports to change to begin with 20
instead of 50.
-m <s> - Compatibility mode
3.2.X = default, keeps change of using 20 instead of 50
3.1.X = changes 20 back to 50 (use if you just upgraded from version 3.1.x or
version 3.2.x with the hp_3.2.2_reboot_101.zip patch installed)
2.X = changes 20 back to 50 (use if you just upgraded from version 2.x and you
have UNIX servers connected to the VLS over the SAN)
CLI Management commands to: