Output Commands; Vls Commands; Network Settings Configuration Commands - HP 12000 User Manual

Output Commands

Use the CLI commands in
for the CLI commands.
Table 15 CLI Output Commands
Command
trace
verbose
version
help
enableVlsLog
disableVlsLog

VLS Commands

This section describes the VLS commands in the VLS CLI command set.

Network Settings Configuration Commands

Use the CLI commands in
settings via a serial session. See
Changing the network configuration parameters modifies four system files:
/etc/hosts
/etc/sysconfig/network
/etc/resolv.conf
/etc/sysconfig/network-scrips/ifcfg-eth1
Table 16 CLI Network Settings Configuration Commands
Command
showConfig
setConfigValue
<-tag> [value]
136 CLI Command Set
CLI output commands
Description
Displays the stack trace after an exception has occurred.
Toggles verbose output on and off. When on, all messages are output to the screen.
Indicates current CLI version. If verbose is on, the module revisions display also.
Displays CLI command usage information. Where <-tag> can be:
-c<command> - Provides help information for the specified CLI command.
-all - Lists all CLI commands and their help information.
Enables VLS logging. Where the options are:
-d<n> - Debug level (1 to 9) (optional)
-h - Displays command usage information (optional)
Disables VLS logging. Where the options are:
-d<n> - Debug level (1 to 1) (optional)
-h - Displays command usage information (optional)
CLI network settings configuration commands
"Opening a Serial Session" (page
Description
Lists host name, DNS domain name, DNS address, and various other addresses. This
command shows both the current internal values, as well as the original values. It also
lists the current and new content of all files affected by the changes.
Sets the value of the corresponding configuration parameter. To reset a value, enter " "
(quoted space) as the value. More than one tag and value can be set at a time. Where
<-tag> can be:
-host - Host name (such as vlsexamp) (unqualified)
-domain - DNS domain name (such as xyz.com)
-fullhost - Fully qualified name (such as vlsexamp.xyz.com)
—ntpPrimary - First NTP Server Address
—ntpSecondary - Second NTP Server Address
-dnsaddr - DNS server address (replaces all addresses with one line)
-dnsaddr1 - First DNS server address (cannot use with dnsaddr)
to control the output and display help information
to configure the VLS network
82).