Network - Bosch NBC-225-P Installation And Operation Manual

IP Camera 200 Series
6.8

Network

Network
>
>
>
>
6.8.1 Network
The settings on this page are used to integrate the device into a
network. Some changes only take effect after a reboot. In this
case Set changes to Set and Reboot.
1.
2.
The device is rebooted and the changed settings are activated.
If the IP address, subnet mask, or gateway address is changed,
then the device is only available under the new addresses after
the reboot.
Automatic IP assignment
If a DHCP server is employed in the network for the dynamic
assignment of IP addresses, activate acceptance of IP
addresses automatically assigned to the device.
Certain applications (VIDOS, Bosch Video Management System,
Archive Player, Configuration Manager) use the IP address for
the unique assignment of the device. If using these
applications, the DHCP server must support the fixed
assignment between IP address and MAC address, and must be
appropriately set up so that, once an IP address is assigned, it
is retained each time the system is rebooted.
IP address
Enter the desired IP address for the camera. The IP address
must be valid for the network.
Subnet mask
Enter the appropriate subnet mask for the set IP address.
Bosch Security Systems
Network
Advanced
Multicasting
JPEG Posting
Make the desired changes.
Click Set and Reboot.
Installation and Operation Manual
Advanced Mode | en
AR18-09-B003 | v1.1 | 2010.05
71