Installing The Controller Cache Module; Installing The Controller - HP 201723-B21 - StorageWorks Modular SAN Array 1000 Hard Drive Maintenance And Service Manual

5.
After the battery pack is hooked in position, swing the pack downward, ensuring that the bottom
clip and two pegs line up with the holes in the cache module.
6. Verify that the top hook (1) and bottom clip (2) on the battery pack are securely attached to the
cache module.
7. Repeatstep 4
8.
Install the serviced cache module in the controller as instructed in
module.
NOTE:
The cache is disabled while the batteries are charging and is automatically re-enabled after the batteries
are fully charged.

Installing the controller cache module

1. Slide the cache module into the controller (1), until the side latches are fully engaged (2).
2.
Close the controller cover.
3.
Insert the serviced controller into the chassis as instructed in

Installing the controller

1.
Insert the new or serviced array controller into the MSA chassis controller bay (1).
2.
Push the controller in as far as it will go, making sure that the controller is seated, and then press the
latch handle inward until it is flush against the front panel (2).
1
2
15520
through step 6 to install the second battery pack on the module.
Installing the controller cache
2
1
15515
Installing the controller.
maintenance and service guide
81