TUNER
These are the basic steps necessary to operate the radio. More advanced tuner operation is
explained starting on page 118.
➲
This cannot be used unless AV Head Unit is combined and the source unit is connected by
IP-BUS.
4
1
5
BAND
1
Shows which band the radio is tuned to AM or FM.
FREQUENCY
2
Shows to which frequency the tuner is tuned.
PRESET NUMBER
3
Shows what preset has been selected.
STEREO indicator
4
Shows that the frequency selected is being broadcast in stereo.
LOC indicator
5
This is indicated unless local seek turning is turned OFF.
■How to listen to the radio
1 Press SOURCE button to select the tuner.
2 Use VOL dial to adjust the sound level.
Rotate to increase or decrease the volume.
3 Press BAND/ESC button to select a band.
Press BAND/ESC button until the desired band is displayed, FM 1, FM 2, FM 3 for FM
or AM.
4 To perform manual tuning, press 2 2 2 2 or 3 3 3 3 with quick presses.
The frequencies move up or down step by step.
5 To perform seek tuning, press and hold 2 2 2 2 or 3 3 3 3 for about one second and release.
The tuner will scan the frequencies until a broadcast strong enough for good reception is
found.
➲
You can cancel seek tuning by pressing either
➲
If you press and hold
soon as you release the buttons.
3
2
N/A
NAVI/AV
button
2 2 2 2
3 3 3 3
or
you can skip broadcasting stations. Seek tuning starts as
2 2 2 2
3 3 3 3
or
with a quick press.
117