Table of Contents
Advertisement
VG4 Modular Camera Series
The following table lists the Power Supply Box connectors:
No.
P101
P105
P106
P107
Table 3.1 Power Box Connections
3.5
Installing the VG4-A-9230 Roof Parapet Mount
This section details the installation steps for the Roof Parapet Mount. If you are installing a
pipe mount, see Section 3.6 Installing the VG4-A-9543 Pipe Mount, page 58, for instructions.
Figure 3.5 VGA-A-9230 Parapet Roof Mount
1.
NOTICE! Allow enough room below the Parapet Mount Bracket to route the video, control and
alarm wires up through the Parapet arm. In certain installations you may have to lift the
Parapet arm for the AutoDome to clear the top of the wall when it is swung into position.
Provide enough slack in the wires to rotate the pipe arm over the roof and back when camera
maintenance is required.
Bosch Security Systems, Inc.
Connector
Pin 1
Ground
Grounding Screw
115/230 VAC or 24
Line
VAC Power In
Control to Dome
C-
(Fiber Optic
(Biphase)
Model)
Control In/Out
C-
(Optional)
(Biphase)
24 VAC Power to
Dome
Dome Plug
24 VAC
Determine the wall location on the roof for the AutoDome and use the Parapet wall
mount bracket as a template to mark the hole locations.
Installation Manual
Installing Roof Parapet and Pipe Mounts | en
Pin 2
Pin 3
Pin 4
NC
Neutral
C+
Earth
RXD (+)
(Biphase)
Ground
(RS-232/485)
C+
Earth
RXD (+)
(Biphase)
Ground
(RS-232/485)
Dome
Earth
Heater
24 VAC
Ground
(24 VAC)
55
Pin 5
Pin 6
TXD (-)
Signal
(RS-232/485)
Ground
TXD (-)
Signal
(RS-232/485)
Ground
Heater
(24 VAC)
F.01U.216.010 | 8.0 | 2011.02
Hide quick links:
Advertisement
Table of Contents
