Make Connections In The Power Supply Box - Bosch VG4-161-CC0 Installation Manual

VG4 Modular Camera Series
5.
CAUTION!
You must tighten the two mounting screws to a minimum torque of 10-12 N-m (90-105 in.-lbs)
to ensure a proper seal between the arm and the housing.
3.11.6

Make Connections in the Power Supply Box

The following procedure references Figure 3.6, Page 56 to locate the various connectors in the
box and to make the proper connections.
1.
2.
3.
Bosch Security Systems, Inc.
Hold the housing in position while tightening the two (2) 5-mm Allen head mounting
screws on top of the housing to 10-12 N-m (90-105 in.-lbs).
Figure 3.19 Tighten Pendant Connection
1 Rotate down to engage dome connector.
2 Tighten the two (2) mounting screws to a minimum torque of 10-12 N-m (90-
105 in.-lbs).
Attach the earth ground wire to the grounding screw on the left side of the box.
Connect the 24 VAC to Dome plug, installed previously, to its mating connector P107 on
the right side of the box.
Connect the 115/230 VAC, 3-pin Power-In plug, installed previously, to its matting
connector P101 on the left side of the box.
Installation Manual
Installing Roof Parapet and Pipe Mounts | en
F.01U.216.010 | 8.0 | 2011.02
71