Fcc Warning - Kenwood SS-992 Instruction Manual

Power Output General
Continuous Rated Power Output (FTC)
Power Consumption ----.-:-.---:ecccescseseeseneteseesseereeeenes 90 W
Center .
AC Outlet (UNSWITCHED)
35 watts minimum RMS, at8 ©, 1kHz with no morethan For the U.S.A. and Canada -.-..-..-.-..--- 1(25 W, 0.2 A max.)
0.9% total harmonic distortion For other COUntries ------.---+---0+:.-eeeesseeeteteees 1 (25 W max.)
DEMO@NSIONS -+--0--seeeee cece cece reeset eee ec teces W : 440 mm (17 -— 5/16")
Rear H: 99mm( 3-7/ 8°)
D:285mm{11-1/ 4°)
15 watts per channel minimum RMS, both channels
driven, at 8 ©, 1 kHz with no more than 0.9% total Weight (met) ..:----.:-ceeecceeceseersreeerseneesereresereee 5.6 kg (12.3 Ib)
harmonic distortion
Total harmonic distortion
CONter ice see essen esssceesssssesesssecees 0.08 % (1 kHz, 17.56 W, 8 Q)
SC): | ee 0.08 % (1 kHz, 7.5 W + 7.5 W, 8 Q)
Frequency Response
{LINE QUT) ----:eseeceeeseeseeeeecees 10 Hz ~ 40 kHz, 0 dB, -3 dB
Signal to Noise Ratio
(LINE OUT) eecrewaiiaienenianioninns 95 dB (IHF A)
Input Sensitivity/Impedance ----.-----------.----.- 200 mV/47 kQ
Output Level/Impedance
LINE GUT acess tee ee oe eis 1 V/2.2 kQ
PRE OUT .-----------:e ee ee etree rn ree 1 V/2.2 kQ
Note:
KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice.
For CANADA
DOC REGULATION
"This digital apparatus does not exceed the CLASS B limits for radio noise emissions from digital apparatus as set out in the radio interference
regulations of the Canadian Department of Communications."
For the U.S.A.
FCC WARNING:
» This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference
unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an
unauthorized change or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause
harmful interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
foliowing measures:
—— Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
ss—g92 (En) 15
a