In Case Of Difficulty - Kenwood SS-992 Instruction Manual

Av surround processor
Hide thumbs Also See for SS-992:
Table of Contents

Advertisement

In case of difficulty
i
ee
What appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult the table
below to see if the problem can be corrected before seeking help from your dealer or service representative.
Sound is not output.
e The speaker cords are disconnected.
e@ Connect them properly referring to "Sys-
tem connections".
@ The VOLUME is set to the minimum posi- | @ Adjust the volume to a proper level.
tion.
e The audio cords are disconnected.
@ Check the audio cords connections.
Sound is not output from the Surround
| @ The rear-speaker cords are disconnected.
@ Connect them properly referring to "Sys-
rear speaker and/or their sound is very
tem connections".
small.
e@ The REAR
LEVEL is set to the minimum | @ Adjust the REAR LEVEL controls.
level.
e The BYPASS mode has been set. Or the | @ Select a Surround mode {DOLBY SUR-
Dolby 3 STEREO mode has been selected.
ROUND, HALL or THEATER).
@ The audio source is monaural.
@ Set the surround position to HALL.
(When the audio source is monaural, sound
is Not output from the rear speakers when
the unit is set to the DOLBY SURROUND or
THEATER surround position.)
@ The TAPE 2/ADAPTOR key on the amplifier
| @ Press the TAPE 2/ADAPTOR key so that
(KA-892,KA-893,KC-992 or KC-993) front
lights up.
panel is not depressed.
Remote control unit provided with the | @ The TAPE 2/ADAPTOR switch on the ampli- | @ Set to ADAPTOR.
amplifier (KA-892,KA-893,KC-$92 or KC-
fier rear panel is set to TAPE.
@ Connect them properly referring to "Sys-
993) cannot be used.
e The system control cords are disconnected.
tem
connections".
Notes:
1, This system is microprocessor-controlled, so malfunction may occur due to external noise or interference noise. In such a case, unplug the power
cord, plug it and turn power on again,
2. Do not use contact cleaners because it could cause a malfunction. Be specially careful against contact cleaners containing oil, for they may deform
the plastic components.
44° ss - 992 (En)

Advertisement

Table of Contents
loading

Table of Contents