23.2.3 Display board/selector assembly TC5/TC4/TC3
Remove the worktop (see relevant paragraph).
Remove the control panel (see relevant paragraph).
Pull out the flat cable connector from the selector socket.
Release the tabs which secure the board to the control panel.
Firstly those shown by the blue arrows.
Then those shown by the red arrows.
Release the hooks indicated by the arrows to remove the board from
its casing.
When putting the display board assembly back together on the control
panel, position it parallel to the control panel with the tabs positioned
above the stops.
Push the display board assembly so that the hooks slot into the
respective tabs simultaneously.
Selector control.
Pull out the flat cable connector from the socket.
Remove the two screws securing it to the control panel (red arrows).
Unhook the tabs that fix it to the control panel (blue arrow).
99/124
Technical Support - DMM
599 75 58-67 Rev.04