Table of Contents
Advertisement
26
www.aeg.com
2. Push the hook to open the filter.
3. Gather lint with hand from both
internal parts of the filter.
Throw the lint in the dustbin.
4. If necessary, clean the filter with a
vacuum cleaner. Close the filter.
5. If necessary, remove lint from the
filter socket and gasket. You can use
a vacuum cleaner. Place the filter
back inside the filter socket.
12.2 Emptying the water
container
Empty the condensed water container
after each drying cycle.
If the condensed water container is full,
the program stops automatically. The
Tank symbol comes on the display and
you must empty the water container.
To empty the water container:
1. Pull the water container out keeping
it in a horizontal position.
2. Pull the plastic connection out and
drain the water into a basin or
equivalent receptacle.
3. Push the plastic connection back in
and place the water container back
into position.
4. To continue the program press the
Start/Pause button.
12.3 Cleaning the condenser
Condenser flashes on
If the symbol
the display, inspect the condenser and
its compartment. If it is dirty, clean it. Do
the check not less than once a 6 months.
WARNING!
Do not touch the metal
surface with bare hands.
Risk of injury. Wear
protective gloves. Clean
carefully to avoid damaging
the metal surface.
To inspect:
Advertisement
Table of Contents
