Table of Contents
Advertisement
12
www.aeg.com
To connect the appliance to enjoy the full
range of features and services you need:
• Wireless network at home with
internet connection enabled.
• Mobile device connected to wireless
network.
Frequency
Protocol
Max power
Minimum requirements:
Operating system
compatibility iOS 15/Android
7.1 and above. Install the
AEG App, create an account
and accept the Terms and
Conditions and AEG Privacy
Policy to use the connected
features. Stable Internet and
good Wi-Fi connection with
2.4GHz wireless frequency
is required. Minimum
requirements, apps and
services are subject to
change without notice.
6.1 QR code on rating plate
QR code can be used in two ways:
• Scan the QR code with the built-in
camera app to register your product.
• Pairing your smart device with
appliance to simplify the process.
Scan the QR code with QR code
scanner built-in AEG App application.
2.4 GHz according to lo‐
cal country regulation
IEEE 802.11b/g/n
According to local coun‐
try regulation
SCANNING...
Mod. xxxxxxxxx
Prod.No.
910000000 00
000V ~ 00Hz 0000 W
00A
00000000
6.2 Installing AEG App
When connecting the tumble dryer to the
application, stand near it with Your smart
device.
Make sure that your smart device is
connected to the wireless network.
1. Go to the App Store on your smart
device or scan QR code (
"QR code on rating plate" ).
2. Download and install AEG App.
3. Make sure you started a Wi-fi
connection in the dryer. If not go to
the section below.
4. Start the application. Select the
country and language and login with
Your email and password. If you do
not have an account, create a new
one following the instructions in AEG
App.
6.3 Wireless connection
configuration
Before you begin the configuration
download and install AEG App
application on your smart device.
1. Push the On/Off button to switch on
the appliance.
2. Wait approximately 8 seconds.
3. Press and hold the Remote Start
button for around 3 seconds until you
hear a single 'click' sound.
The symbols:
and
display. After few seconds only flashing
symbol:
remains. Appliance is
starting up the connection, it takes
around 10 second for the wireless
module to activate. When ready the
symbol:
(Access Point) appears on
the display. Access Point is open for
around 3 minutes.
4. Configure the AEG App on your
smart device and follow the on
screen instructions to connect the
appliance to your WiFi network.
5. If the connection is established,
symbol is off and the
stays lit steadily.
see chapter
appear on the
WiFi icon
Advertisement
Table of Contents
