AEG T738A4OBC User Manual page 18

18 www.aeg.com
The cycle lasts as long as
set drying time regardless of
the size of a load and its
dryness.
TIME DRYING RECOMMENDATION
up 10 action of cool air only (no heat‐
min er).
additional drying to improve dry‐
10 - 40
ness after previous drying cy‐
min
cle.
full drying of the small laundry
> 40
loads up to 4 kg, well spun
min
(>1200 rpm).
Time Dry on Wool program
Option applicable to Wool program to
adjust final dryness level to more dry or
less dry.
8.3 + Anti Crease
Extends up to 120 minutes the anti-
crease phase (30 minutes) at the end of
the drying cycle. After drying phase drum
rotates from time to time to prevent
creases. Laundry can be removed during
the anti-crease phase.
8.4 Silent
The appliance operates with low noise
without effect on the drying quality. The
appliance operates slowly with longer
cycle time.
8.5 End Signal
The acoustic signal sounds at the
following:
• cycle end
• start and end of crease guard phase
The acoustic signal is by default always
on. You can use this option to activate or
deactivate the sound.
8.6 Finish In
This option allows choosing
the time at which a program
should terminate. Once
activated the machine waits
for the right moment to begin
the drying process.
Finish In time is the sum of stand by time
and drying time.
To set the Finish In option:
1. Set the drying program and options.
2. Touch Finish In repeatedly until the
display shows the desired time within
the program should end (e.g.
if the program has to finish within
12 hours.)
3. Touch the Start/Pause button. The
drum starts rotating to perform the
ProSense estimation, if foreseen in
the selected program.
4. The appliance starts the countdown
to the end of the program and the
program will start at the right moment
for ending.
8.7 Favourite programs
These selector positions are available
after the appliance have been connected
to Wi-Fi.
The favourite programs can be set and
saved via App only choosing from the
available ones which are divided into the
three categories indicated on the control
panel.
Once the favourite programs have been
set, you can select one of them via App
or by turning the program dial to relevant
position: the relevant led comes on and
the information on the display are
updated accordingly.
The favourite program can
be cancelled through the
related App command or
pressing the Factory Default
key combination.