Configuring Arp Automatic Scanning And Fixed Arp; Configuration Guidelines; Configuration Procedure - HP 3600 v2 Series Configuration Manual

Configuring ARP automatic scanning and fixed ARP

ARP automatic scanning is usually used together with the fixed ARP feature.
With ARP automatic scanning enabled on an interface, the device automatically scans neighbors on the
interface, sends ARP requests to the neighbors, obtains their MAC addresses, and creates dynamic ARP
entries.
Fixed ARP allows the device to change the existing dynamic ARP entries (including those generated
through ARP automatic scanning) into static ARP entries. The fixed ARP feature effectively prevents ARP
entries from being modified by attackers.
HP recommends that you use ARP automatic scanning and fixed ARP in a small-scale network such as a
cybercafe.

Configuration guidelines

Follow these guidelines when you configure ARP automatic scanning and fixed ARP:
IP addresses existing in ARP entries are not scanned.
•
ARP automatic scanning may take some time. To stop an ongoing scan, press Ctrl + C. Dynamic
•
ARP entries are created based on ARP replies received before the scan is terminated.
• The static ARP entries changed from dynamic ARP entries have the same attributes as the manually
configured static ARP entries.
Use the arp fixup command to change the existing dynamic ARP entries into static ARP entries. You
•
can use this command again to change the dynamic ARP entries learned later into static ARP
entries.
The number of static ARP entries changed from dynamic ARP entries is restricted by the number of
•
static ARP entries that the device supports. As a result, the device may fail to change all dynamic
ARP entries into static ARP entries.
To delete a specific static ARP entry changed from a dynamic one, use the undo arp ip-address
•
[ vpn-instance-name ] command. To delete all such static ARP entries, use the reset arp all or reset
arp static command.

Configuration procedure

To configure ARP automatic scanning and fixed ARP:
Step
1. Enter system view.
2. Enter interface view.
3. Enable ARP automatic scanning.
4. Return to system view.
5. Enable fixed ARP.
Command
system-view
interface interface-type interface-number
arp scan [ start-ip-address to end-ip-address ]
quit
arp fixup
388