Configuring Port Security Features; Configuring Ntk; Configuring Intrusion Protection - HP 3600 v2 Series Configuration Manual

Step
4. Set the port security
mode.

Configuring port security features

Configuring NTK

The NTK feature checks the destination MAC addresses in outbound frames to make sure that frames are
forwarded only to authenticated devices. Any unicast frame with an unknown destination MAC address
is discarded. Not all port security modes support triggering the NTK feature. For more information,
see Table 13.
The NTK feature supports the following modes:
ntkonly—Forwards only unicast frames with authenticated destination MAC addresses.
•
• ntk-withbroadcasts—Forwards only broadcast frames and unicast frames with authenticated
destination MAC addresses.
ntk-withmulticasts—Forwards only broadcast frames, multicast frames, and unicast frames with
•
authenticated destination MAC addresses.
To configure the NTK feature:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view.
3. Configure the NTK feature.

Configuring intrusion protection

Intrusion protection enables a device to take one of the following actions in response to illegal frames:
blockmac—Adds the source MAC addresses of illegal frames to the blocked MAC addresses list
•
and discards the frames. All subsequent frames sourced from a blocked MAC address will be
dropped. A blocked MAC address is restored to normal state after being blocked for three minutes.
The interval is fixed and cannot be changed.
disableport—Disables the port until you bring it up manually.
•
Command
port-security port-mode { autolearn |
mac-authentication |
mac-else-userlogin-secure |
mac-else-userlogin-secure-ext | secure
| userlogin | userlogin-secure |
userlogin-secure-ext |
userlogin-secure-or-mac |
userlogin-secure-or-mac-ext |
userlogin-withoui }
Command
system-view
interface interface-type
interface-number
port-security ntk-mode
{ ntk-withbroadcasts |
ntk-withmulticasts | ntkonly }
203
Remarks
By default, a port operates in
noRestrictions mode.
Remarks
N/A
N/A
By default, NTK is disabled on a
port and all frames are allowed to
be sent.