Level 1 And Level 2 Maintenance; Table 12: Lead Free Solder Wire Part Number List; Table 13: Lead Free Solder Paste Part Number List - Motorola MXP600 Manual

Hide thumbs Also See for MXP600:

Table of Contents

Table 12: Lead Free Solder Wire Part Number List

Motorola

Alloy

Solutions

Part Number

1088929Y01

95.5Sn/3.8Ag/

0.7Cu

Table 13: Lead Free Solder Paste Part Number List

Motorola

Manufacturer

Solutions

Part Number

1085674C03

NC-SMQ230

Parts Replacement and Substitution

When damaged parts are replaced, identical parts must be used. If the identical replacement part is not

locally available, check the parts list for the proper Motorola Solutions part number and order the part.

Rigid Circuit Boards

This family of radios uses bonded, multilayer, printed circuit boards. Special considerations are

required when soldering and desoldering components as the inner layers are not accessible. The

plated-through holes may interconnect multiple layers of the printed circuit. Therefore, exercise care to

avoid pulling the plated circuit out of the hole.

When soldering near a connector:

•

Avoid accidentally getting solder in the connector.

•

Be careful not to form solder bridges between the connector pins.

•

Examine your work closely for shorts due to solder bridges.

For soldering components with Hot-Air or infrared solder systems, check the user guide of your solder

system to get information on solder temperature and time for the different housings of the integrated

circuits and other components.

Care After Submersion

The radio (device with antenna and battery assembled) is IP68 compliant. It is fully protected from

dust, and can withstand being submerged up to 2 hours in two meters of static water.

If the device has been submerged in water, shake the device to remove any water that is trapped

inside the speaker grille and microphone port. Otherwise, the water will decrease the audio quality and

connectivity performance of the device.

Ensure that no water has penetrated the seal. Check the interface if any accessory or the Universal

Connector Dust Cover is covering the Universal Connector and Bottom Connector. Water left in this

interface can degrade the performance of the accessories.

5.4