Yamaha MY16-CII Owner's Manual page 22

For yamaha my16-cii network i/o card

Hide thumbs Also See for MY16-CII:

Table of Contents

Note: When Conductor Priority is set to a value other than "Auto", the value specified via the

CobraNet Manager takes priority.

Note: The MY16-C conductor priority is automatically set to the same values as the MY16-CII

according to the three available clock modes, but the MY16-C conductor priority setting cannot be

changed manually.

Conductor Priority Should Be Set Manually When...

With some types of connection, word clock loops may occur when Conductor Priority is set to

"Auto" resulting in network instability. In such cases set conductor priority to prevent the

occurrence of loops.

CobraNet device

MY16-CII

PM5D

In this example Conductor Priority is set to "Auto" so the MY16-CII installed in the DME64N

becomes a conductor and a word clock loop is created. To rectify this problem it is necessary to

either lower the conductor priority of the MY16-CII installed in the DME64 or raise the conductor

priority of the MY16-CII installed in the PM5D, thus preventing the MY16-CII installed in the

DME64N from functioning as conductor.

CobraNet Manager Lite for Yamaha Owner's Manual

Network

CobraNet Synchronization signal flow

Network Sync

performer

Clock

Figure 28: Conductor Priority needs to be set manually

MY16-CII

DME64N

U.R.G.,Pro Audio& Digital Musical Instrument Division, Yamaha Corporation

Host Sync 1

conductor

Table of Contents

Cobranet manager lite