Honeywell MPA2C3 User Manual page 29

Tip:
Panels, and what doors they control. This will be useful later when the
panels are configured. Example list below
DIP switches 5 through 9 should be set to factory defaults:
•
•
One of the controllers must be set as the Primary controller by setting DIP Switch 3
to ON.
MPA2C3 User Manual
When setting up an EVL loop, create a list of MAC addresses for all
Panel Address IP Address
1 1 192.168.1.150xx:xx:xx:xx:xx:xx
2 1 DHCP yy:yy:yy:yy:yy:yy
3 1 DHCP zz:zz:zz:zz:zz:zz
DIP switches 5 through 8: OFF.
DIP switch 9: ON.
List of MPA2 EVL system
MAC Address Primary / Secondary2/4 door Door1
Master
Secondary
Secondary
.
Door2
2 Lobby Office 1
4 WarehouseCorridor WestCorridor East Office 2
2 Office 3 Back door
Door3 Door4
29