Miele DA 3160 Operating And Installation Instructions page 32

installation
7. Venting
Air extraction mode
[] Complete the venting installation, see
"Air extraction",
Flecirculation mode
If the hood cannot be installed for air
extraction the appliance must be
connected for recirculation mode,
For recirculation mode a respective
installation kit is recommended which
can be obtained from Miele,
In addition an active charcoal filter is
needed,
o,!
[] The non-return flap is not needed for
the recirculation mode, Pull the
non-return flap off the bracket from
the vent connection,
[] Insert the hose from below into the air
outlet grille,
[] Insert the hose from the top though
the opening in the cabinet,
[] Secure the ventilation hose on the
vent connection of the hood using a
hose clip,
The non-return flap is not used in
recirculafion mode,
[] Screw the air outlet grille onto the
cabinet top,
Make sure that the slats in the grill
point towards the center of the room
and not towards a wall or the ceiling,
[] Install the Active Charcoal Filter (see
"Cleaning and care"),
8. Emectrical connection
32
i connection" and "Important Safety
Instructions" before connecting to
the mains.
[] Plug in the power cord,