ABB IRC5 Product Manual page 188

4 Repair
4.10 Replacement of SD-card memory in computer unit
Continued
Required equipment
Equipment
SD-card 2GB
Standard toolkit
Removal
Use the following procedure to remove the SD-card memory.
1
2
3
Refitting
Use the following procedure to refit the SD-card memory.
1
2
3
Continues on next page
188
Action
DANGER
Before doing any work inside the cabinet, disconnect the mains power. For more
information, see Electrical safety on page
ELECTROSTATIC DISCHARGE (ESD)
The unit is sensitive to ESD. Before handling the unit read the safety information
in section The unit is sensitive to ESD on page
Gently push the SD-card memory with your finger until it clicks, and then pull it
straight out.
Action
DANGER
Before doing any work inside the cabinet, disconnect the mains power. For more in-
formation, see Electrical safety on page
ELECTROSTATIC DISCHARGE (ESD)
The unit is sensitive to ESD. Before handling the unit read the safety information in
section The unit is sensitive to ESD on page
CAUTION
Make sure that the SD-card memory is correctly oriented before inserting it. Otherwise
the SD-card memory or the SD-card memory slot may be damaged.
© Copyright 2007-2024 ABB. All rights reserved.
Note
See Spare parts on page
Note
Only use SD-card memory supplied by
ABB.
Includes ABB Boot Application software
to correctly reboot the robot controller.
The content is described in section
Standard toolkit, IRC5 on page
35.
48.
35.
48.
Product manual - IRC5 Panel Mounted Controller
3HAC047137-001 Revision: AB
253.
249.