Table of Contents
Advertisement
(4. 3)
Changing black gamma correction level
© Set the
to BLACK GAMMA by pushing [MENU UP], [MENU DOWN] buttons.
(D Select black gamma correction by pushing [DATA UP], [DATA DOWN] buttons.
[DATA UP]
p LOWi NORMAL J HIGH
d
[DATA DOWN]
I
* When OFF is selected in GAMMA ON/OFF selection line, the display BLACK GAMMA turns off
automatically. So the black gamma correction level change cannot be changed.
(4. 4) Changing two-dimension low pass filter
(D Set the
to 2D LPF by pushing [MENU UP], [MENU DOWN] buttons.
(D Select either ON or OFF by pushing [DATA UP], [DATA DOWN] buttons.
* When ON is selected, the cross color noise in VBS output is reduced.
Note:
Select OFF in step 2 described above when using signals other than the VBS output.
When OFF is selected in the GAMMA ON/OFF line or when DTL OUT ON is selected in the OPTION
menu, the display 2D LPF turns off automatically. So 2D LPF change cannot be performed. (2D LPF is
set to OFF.)
(4. 5) Changing detail (outline) gain
© Set the
" to DTL GAIN by pushing [MENU UP], [MENU DOWN] buttons.
(D Set the detail gain by pushing [DATA UP], [DATA DOWN] buttons.
[DATA UP]-► The detail increases.
—7<
-► 0
<
-► 7
The detail decreases. ◄-[DATA DOWN]
* When DTL OUT ON is selected in OPTION menu, the display DTL GAIN turns off automatically. So
DTL GAIN change cannot be performed.
(4. 6) Changing detail boost frequency
© Set the
to DTL B.FREQ by pushing [MENU UP], [MENU DOWN] buttons.
(D Set the detail boost frequency by pushing [DATA UP], [DATA DOWN] buttons.
|
[DATA UP]
p LOW^ NORMAL
T
HIGH
d
[DATA DOWN]
33
Advertisement
Table of Contents
