ML-13000
User's Manual
B
Hold the handles on the front of the belt cleaning unit to pull it out.
A
Handles
C
Apply grease to the moving parts of the belt cleaning unit with a grease tube.
D
Push the belt cleaning unit back to its original position.
Removing Ink Film
If the adhesive strength of the glue applied to the belt decreases about a week after applying the glue, there is a
possibility that the ink has stuck to the belt and formed a film. Remove ink stuck to the belt.
This section describes the procedures for using the ink film remover recommended by Epson. Allow at least 8
hours for the belt to dry after performing this operation.
Check and address the following to prevent an ink film from forming.
Maintenance
273