Table of Contents
Advertisement
Electrical Wiring
Stranded wire
1. Cut the wire end with cutting pliers, then strip the insulation to expose the stranded wiring about
2. Using a flat-blade screwdriver, loosen the terminal screw(s) on the terminal plate.
3. Attach a wire-end sleeve to each stripped wire end using a crimping tool.
4. Place the wire-end sleeve into the socket on the connector and replace and tighten the removed
5
Shielded wire
1. Remove cable sheath. Take care not to scratch braided shield.
2. Unbraid the braided shield mesh carefully and twist the unbraided shield mesh tightly together.
3. Remove insulation of signal wire.
4. Attach wire-end sleeves to the signal wires and the shield mesh insulated in step 2 using a
5. Connect the shield for the inter-unit control wiring to ground.
54
10 mm and tightly twist the wire ends.
Wire-end
sleeve
terminal screw using a flat-blade screwdriver.
Screw
Special washer
Terminal plate
Wire-end sleeve
Wire
Insulate the shield mesh by covering them with an insulation tube or wrapping insulation tape
around wire.
Insulation tape
Insulation tape
crimping tool.
Screw and special washer
Wire
Wire-end sleeve
Shield mesh
Shield mesh
Wire-end sleeve
AHU Kit – Installation Instructions – 07/2023
Advertisement
Table of Contents
