Table of Contents
Advertisement
eae
Vou warsnoasiai |
Your Information
Precautions
ry
On safety
¢ Operate the printer on 120 V AC, 60 Hz only.
¢ Be careful not to set or drop any heavy objects on the
power cord, or to damage the cord in any way. Never
operate this printer with a damaged power cord.
¢ Should any solid object or liquid fall into the cabinet,
unplug the printer and have it checked by qualified
personnel before operating it any further.
¢ Never disassemble the printer.
¢ To disconnect the cord, pull it out by the plug. Never
pull the cord itself.
¢ When the printer is not going to be used for an
extended period of time, disconnect the power cord
from the wall outlet.
¢ Do not handle the printer roughly.
¢ To reduce the risk of electrical shock, always unplug
the printer from electrical outlet before cleaning and
servicing the printer.
On installation
¢ Avoid placing the unit in a location subject to:
~ vibration
— high humidity
— excessive dust
— direct sunlight
— extremely high or low temperatures
¢ Do not use electronic equipment near the unit. The unit
will not work properly in electromagnetic fields.
The unit is designed to operate horizontally. Never
attempt to operate the printer in a tilted position.
If the unit was placed on its side or with its top panel
facing down, make sure to remove the paper tray and
check that print papers are set properly before starting
operation.
Do not place heavy objects on the printer.
¢ Leave enough room around the printer so that the
ventilation holes are not blocked. Blocking these holes
may cause internal heat build-up.
On operation
e If the temperature inside the unit rises too high, the
internal fan automatically starts rotating to keep the
appropriate temperature for printing.
* To avoid malfunction, do not record on the VCR the
output signal from the MONITOR OUT jack of the
unit.
For Your information
On moisture condensation
If the printer is brought directly from a cold location to
warm location or placed in an extremely warm or humid
room, moisture may condense inside the unit. In such
cases the printer will probably not work properly and
may even develop a fault if you persist in using it. Ié
moisture condensation occurs, turn off the power and do
not use the printer for at least one hour.
On cleaning
Clean the cabinet, panel and controls with a soft dry
cloth, or a soft cloth lightly moistened with a mild
detergent solution. Do not use any type of solvent, such
as alcohol or benzine, which may damage the finish.
On the print cartridge and
print paper
On the print cartridge
To replace the print cartridge
If the completely used print cartridge is still inserted in
the unit, the error message "Out of ink ribbon. Insert new
cartridge." appears on the TV screen. Pull down the lever
and remove the print cartridge as illustrated below to
replace the print cartridge with a new one.
You cannot reuse a print cartridge that has been
completely used.
Remove the print
cartridge
Pull down the lever
When you use a partially-used print cartridge
Remove any slack (@). Then, wind the ink ribbon until
the black bar appears on the left (@).
While pressing the center of the
reel, wind the ink ribbon until the
black bar appears on the left.
Advertisement
Table of Contents
