Label Distribution Protocol
To enable LDP on the SDP when an LSP is already specified, the LSP must be
removed from the configuration using the no lsp lsp-name command. For further
information about configuring SDPs, refer to the 7705 SAR Services Guide.
Use the following CLI syntax to enable LDP on an MPLS SDP:
CLI Syntax:
The following example displays an SDP configuration output with the signaling
default tldp enabled.
ALU-1>config>service>sdp# info detail
----------------------------------------------
----------------------------------------------
ALU-1>config>service>sdp#
440
config>service>sdp#
ldp
signaling {off|tldp}
description "MPLS: to-99"
far-end 10.10.10.99
ldp
signaling tldp
path-mtu 4462
keep-alive
hello-time 10
hold-down-time 10
max-drop-count 3
timeout 5
no message-length
no shutdown
exit
no shutdown
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
MPLS Guide
3HE 18686 AAAB TQZZA