Nokia 7705 SAR-W Series Manual page 288

Service aggregation router, mpls

Table of Contents

MPLS and RSVP-TE

lsp-ingress-stats

lsp-ingress-stats [ip-address lsp lsp-name]

clear>router>mpls

This command clears RSVP LSP ingress statistics.

Note: When RSVP LSP statistics are cleared, the current aggregate statistics count is

recorded as a baseline and is used to provide a relative count each time the statistics are

viewed with the show command. Because this baseline number is not reconciled between

the active and inactive CSMs, after a CSM activity switch the statistics on the newly active

CSM will show the aggregate count as though no clear command has been executed.

ip-address — the system IP address of the sender (a.b.c.d)

lsp-name — the name that identifies the LSP

interface [ip-int-name] [statistics]

clear>router>rsvp

This command resets or clears statistics for an RSVP-TE interface.

ip-int-name — identifies the IP interface to clear. The interface name cannot be in the

statistics — clears only statistics

clear>router>rsvp

This command clears global statistics for the RSVP-TE instance; for example, clears path

and resv timeout counters.

form of an IP address. Allowed values are any string up to 32 characters long

composed of printable, 7-bit ASCII characters. If the string contains special

characters (#, $, spaces, etc.), the entire string must be enclosed within double

Use subject to Terms available at: www.nokia.com

3HE 18686 AAAB TQZZA