Yamaha MT44D Operating Manual page 6

REAR PANEL
( YAMAHA NOISE REDUCTION SYSTEM MANUFACTUREO UNDER
LICENSE FROM DOLBY LABORATORIES LICENSING
MULTI TRACK CASSETTE RECORDER CORPORATION "DOLBY" AND THE DOUBLE-D SYMBOL 4,737
MODEL MT44D '
LICENSING CORPORATION 5
18W 50/609: ~ і
NIPPON GAKKI CO. LTD.
va %
MADE IN JAPAN
4. REMOTE CONTROL terminal
The use of a RC 10B remote control unit (op-
tion) enables you to contro! the remote tape
driving process.
1. LINE IN
These are input terminals for recording. For use
of this unit as a 2-channel deck, connect the
terminal 1 to the L-ch terminal and terminal 2 to
the R-ch terminal.
e R-cn
termina
5. REMOTE
PUNCH IN/OUT
. LINE OUT
These are output terminals for playback, For
use of this unit as a 2-channel deck, connect
the terminal 1 to the L-ch terminal and terminal
2 to the R-ch terminal,
. Power source frequency set switch for TIMER
Set this switch to correct frequency according
to your local mains frequency, The switch is
set to 60 Hz when shipping from factory. .
The use of a remote control unit FS1 (option)
enables you to control the remote punch 'in and
out process,
6. Voltage selector (General Model Only)
Set this to your local AC mains voltage, Failure
to do so will result in seriously impaired
performance or even severe damage.