ABB SACE Emax 2 Series Operating Instructions Manual page 212

Interface The module has nine signaling leds:
Output parameters All the available outputs enable the following parameters to be configured:
209 | © 2023 ABB | 1SDH001330R1002 - ECN000297030
Figure 125
LED
Power
O 01, O 02, O 03, O 04
I 01, I 02, I 03, I 04
Menu The specific configuration area will activate in the Settings - Modules menu if the Ekip Signalling 4K module
is connected correctly to Ekip Touch.
The programming submenus of the inputs and outputs are present inside.
Parameter Description
Event which activates the output and changes the state of the contacts.
Different protection proposals, statuses and thresholds are available in
Signal source
the menu; the Custom mode can be configured via Ekip Connect so as to
extend the solutions and combine several events.
Minimum presence of Source for output activation; the Delay is given in
seconds and can be set within a range between 0 s and 100 s, in 0.01 s
steps.
Delay
Defines the rest status of the contact with Source not present between
either: normally open (NO) and closed (NC).
Contact Type
Output activation coincides with the change in state with respect to that
of rest.
Allows the output to be managed differently when Source disappears:
either keep contact activated (On) or deactivate it (Off).
Latched
(1)
Description
Signals the state of the module (on or off)
Indicate the physical state of the contacts of each output:
• off (contact open);
• on (contact closed).
Indicate the physical state of the contacts of each input:
• off (circuit open);
• on (short circuit).
NOTES:
• output will not activate if Source deactivates before Delay has
elapsed
• if delay = 0 s Source must still be present for longer than 300 mS
NOTE: if Self-latching = On, the output resets if the module
switches off, or in the case of a module auto test or signal reset
command
ABB | SACE Emax 2
Default
None
0 s
NO
Off
Continued on the next page
Internal electronic accessories
3 - Ekip Signalling 4K