Advertisement
HSITDNA
76
The vehicle position is not
correctly shown while trav-
eling.
|
| GPS signals cannot be
GPS symbol is not dis-
played.
Distance compensation is
incomplete.
Vehicle speed pulses are
not correctly connected.
received due to an obsta-
cle.
GPS antenna cable con-
| nection is incomplete.
Your car location is not
shown.
No voice guide
Remote control buttons do
not beep,
Map is not displayed
(Screen blank)
The system is in map
mode.
Voice guide volume is set
to zero.
The vehicle is off the route.
The vehicle is going back-
wards on the route.
Beep is set to OFF.
Beep was set improperly
during monitor setup.
Map disc is wet due to con-
densation, scratches, or
dirts.
Turn the beep on.
Check if distance compen-
sation has been completed.
(See page 86.)
Read the manual and
check the connection.
GPS signals will be
received when there are
not any more obstacles.
Check GPS antenna con-
nection with the installation
check screen.
(If the cable
is unconnected, read the
manual and check the con-
nection.)
Press the <POS> button.
Raise the voice guide vol-
ume.
Check the route guide dis-
play on the current position
map. Repeat route search.
Check the direction for your
destination.
Repeat route search.
Set the monitor appropri-
ately for the type of monitor
connected.
Check if the map disc is
wet due to condensation,
scratches, or dirts.
Advertisement
