Toshiba D-R5SU Owner's Manual page 5

Introduction
SAFETY PRECAUTIONS ( Continued )
Note to cable system installer:
This reminder is provided to call the cable system installer's attention to Article 820-40 of the NEC that provides
guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the
grounding system of the building, as close to the point of cable entry as practical.
The instructions shall state that an ALL-POLE MAINS SWITCH with a contact separation of at least 3 mm in each
pole shall be incorporated in the electrical installation of the building.
CAUTION:
These servicing instructions are for use by qualified service personnel only. To reduce the risk of
electric shock do not perform any servicing other than that contained in the operating instructions
unless you are qualified to do so.
In the spaces provided below, record the Model and Serial No. located on the rear panel of your recorder.
Model No Serial No.
Retain this information for future reference.
Location of the required label
O
o
0
o
0
e-
PRODUCT ISCERTIFIED BYTHE
MANUFACTURERTO COMPLY
WITH DNHS RULE 21 CFR
SUBCHAPTERJ IN EFFECT AT
DATEOF MANUFACTURE.
TOSHIBA
CORPORAT|ON
1-1 ,SHIBAURA 1-CHOME,MINATO-KU,
TOKYO 105-8001 ,JAPAN
To [11 outlet
Be aware that this equipment is still powered even after the ON/STANDBY indicator turns off (standby mode)
by pressing the ON/STANDBY button. To disconnect this equipment completely from the mains power,
pullout the power plug from the wall outlet.
WARNING: HANDLING THE CORD ON THIS PRODUCT OR CORDS ASSOCIATED WITH
ACCESSORIES SOLD WITH THIS PRODUCT, WILL EXPOSE YOU TO LEAD, A
CHEMICAL KNOWN TO THE STATE OF CALIFORNIA TO CAUSE BIRTH DEFECTS
OR OTHER REPRODUCTIVE HARM, WASH HANDS AFTER HANDLING,
"O
,<
0"
0
0
o
0_
¢0
tD
r=
0
t_
5