Toshiba D-R5SU Owner's Manual page 24

Introduction
Index to parts and controls ( Continued )
DVD-RAM disc with cartridge (TYPE1/TYPE2/
TYPE4)
Single sided
Turn the printed side up, and insert the cartridge
into the tray frame following the direction of the
arrow on the cartridge.
Double sided
Turn the desired recording/playback side up, and
insert the cartridge into the tray frame following the
direction of the arrow on the cartridge.
3 Close the disc tray,
Press__ on the front panel or OPEN/CLOSE on
the remote control.
Notes
• Use the button on the front panel or the remote control
to open and close the disc tray. Do not push or hold the
disc tray while it is moving. Doing so may cause the
recorder to malfunction.
• Do not insert a disc which is unplayable or any object
other than a playable disc.
• Do not apply downforce to the disc tray. Doing so may
cause the recorder to malfunction.
• If the disc tray stops while closing, the mechanical
protection system of this recorder will open it. Do not
force it to close. Doing so may cause malfunction.
• If the disc tray cannot open, turn the recorder off and
press the A button on the front panel or the OPEN/
CLOSE button on the remote control. This may turn the
recorder on and open the disc tray. If it still won't open,
contact your nearest TOSHIBA dealer.
• The recorder may take several dozens of seconds to
open the disc tray, if a loaded disc contain a large
number of titles or chapters.
• Turning the power off
Press ON/STANDBY on the front panel of the
recorder or t/_ on the remote control.
The LED turns off if it is lighted and the power turns
off (Standby mode.)
Caution
• If the power fails or the power cord is disconnected
from a wall outlet while the recorder is in operation
(LED lit when the front panel display is not dimmed),
the loaded disc may become recording disabled. In
such a case, executing an initialization of the disc
using the formatting function of the recorder may
refresh it. However, all contents stored on the disc will
be completely erased by this initialization process.
• This recorder may indicate alert messages with some
DVD-RAM discs right after insertion. If such a disc is
used for playback or recording on other equipment, all
data in the disc may be damaged and the disc will not
be played. By executing an initialization of the disc
using the formatting function of the recorder, the disc
will become operational.
• If the recorder freezes and does not respond at all,
leave it alone for about 15 minutes or longer. This may
restore the recorder. After the recorder has recovered,
turn it off once and turn it on again to use as usual.
Note
• If there are any performance malfunctions of the disc
drive, immediately discontinue use of this recorder,
and disconnect the power cord from a wall outlet, then
contact your dealer. Continuous use of the recorder in
such a condition will aggravate the condition and result
in increased cost and repair time.
• Disc tray lock (Child lock)
You can lock the disc tray.
Press and hold • (STOP) on the front panel for
longer than about 3 seconds.
To unlock, during stop press the button for longer
than about 3 seconds.
Note
° Turning the power off also unlocks the disc tray.
24