Safety - Husqvarna X-SYNC Operator's Manual

(headband), EN 352-3:2020 (helmet mounted), EN
352-4:2020, EN 352-6:2020 and EN 352-8:2020.
Notified body involved in the conformity assessment
is: Notified body number 1974. PZT GmbH,
Bismarckstraße 264 B, 26389 Wilhelmshaven,
Germany.
Certification and Monitoring by PZT.
The battery is certified according to IEC62133 edition 2.
1974
UK Importer:
Husqvarna UK Ltd
Preston Road, Co. Durham
DL5 6UP
FCC ID: ZASHP500BT, IC: 23307-HP500BT
FCC Compliance Statement:
This device complies with Part 15 of the FCC
Rules.Operation is subject to the following two
conditions: (1)This device may not cause harmful
interference, and(2) this device must accept any
interference received,including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
Safety definitions
Warnings, cautions and notes are used to point out
specially important parts of the manual.
WARNING:
injury or death for the operator or bystanders
if the instructions in the manual are not
obeyed.
CAUTION:
damage to the product, other materials or
2146 - 003 -
Used if there is a risk of
Used if there is a risk of
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Increase the separation between the equipment and
receiver.
• Consult the dealer for help.
Marking on the product is found on the label on the right
earmuff.
ISED Canada Compliance Statement
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science
and Economic Development Canada's licence-exempt
RSS(s). Operation is subject to the following two
conditions:
• This device may not cause interference.
• This device must accept any interference, including
interference that may cause undesired operation of
the device.
CAN ICES-3 (B)/NMB-3(B)
L'émetteur/récepteur exempt de licence contenu dans le
présent appareil est conforme aux CNR d'Innovation,
Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions
suivantes:
• L'appareil ne doit pas produire de brouillage.
• L'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
CAN ICES-3 (B)/NMB-3(B)
Registered trademarks
®
Bluetooth
The
trademarks owned by
of such marks by Husqvarna is under license.

Safety

the adjacent area if the instructions in the
manual are not obeyed.
Note:
Used to give more information that is necessary
in a given situation.
General safety
WARNING:
instructions that follow before you use the
product.
word mark and logos are registered
Bluetooth SIG, inc. and any use
Read the warning
3