Yamaha PX-2 Owner's Manual page 5

PX-
Removing the transit screws
The arm unit has been secured with screws on the
rear side, and by an arm fixing plate on the front
in order to protect the arm unit from vibrations,
etc. during transport. Remove the screws and
fixing plate before using the PX-2. Keep the screws
together with the carton box for future transport.
1. Remove the transport fixing plate. (Front side)
When transporting, do not forget to resecure the
tonearm. Lower the tonearm unit to its lowest
position. Firmly tighten the LOCK A knob and
fix it in position with the arm fixing plate and
vinyl string.
Phillips
screwdriver
-Arm fixing plate
` |
7/ Remove the vinyl string before
Fixing unscrewing the two fixing screws.
screws :2)
Fig. 1
2. Remove the three transport fixing screws. (Rear
side)
When transporting, do not forget to resecure the
arm unit with the fixing screws.
To remove the fixing screws (and also to fix the
arm unit for re-transport), raise the rear side of
the unit.
FAN SÈ
E >Transpont fixing screw
Sl = :
How to fix the arm unit for transport
When it is necessary to transport the unit, the arm
unit should be fixed without fail in the following
seguence to protect the arm unit. Failure to secure
the arm unit when the unit is to be transported
may lead to disorders.
1. After moving the tonearm to the extreme right,
disconnect power. Then, remove the platter,
headshell, dust cover and main weight.
2. Referring to Fig. 2, fix the arm unit in place
with the three transport fixing screws.
3. Referring to Fig. 1, fix the tonearm in place with
the arm transport fixing plate.
Be careful not to over-tighten the fixing screws.
*
Accessories
Dust cover
hinges Cartridge set screws
(l=16mm x 4, |=10mm x 4)
Serial nuts (x 2)
Washers (x 4)
EP adaptor
Cap Headshell
Cartridge setting
Main weight Sub-weights gauge