Yamaha PX-2 Owner's Manual page 11

Before starting disc play, check and confirm proper
connection of power plug, output cord and ground
wire.
Automatic Disc Play
1. Turn on the POWER switch and place a disc on
the platter.
2. Match the platter speed to the disc speed.
(As the turntable will be automatically set to
"33" r.p.m. when power is turned on, the "45"
button of the SPEED switch should be depres-
sed when a 45 r.p.m. disc is to be played.)
3 Matching it with the size of the disc, depress the
PLAY,/DISC SIZE button of that particular size,
This will cause the DISC SIZE indicator to light
up. The platter will start rotating and the tone-
arm will move up to the prescribed AUTO-LEAD-
IN position" at which it will descend to start disc
play. (AUTO-LEAD-IN)
4. When disc play is finished and the tonearm enters
the LEAD-OUT groove on the innermost side of
the disc, the tonearm wil! rise and return to the
extreme right, causing the platter to stop at the
same time. (AUTO-RETURN)
"Prescribed position"
The AUTO-LEAD-IN position is set according to RIAA
— specified records, the position at which the stylus will
lower itself may not match discs that do not conform to
RIAA.
For REPEAT Play
Start REPEAT play by depressing the PLAY/DISC
SIZE switch and then depressing the REPEAT
switch,
REPEAT play will start at the correct position for
the selected size. Likewise, on completion of disc
play, the disc, through AUTO-RETURN, will
return to this position, and play will be repeated.
To release REPEAT play, depress the REPEAT
switch once again. This will cause the indicator
to go out and the REPEAT play mechanism to
be released. Thus, on completion of disc play,
play will be discontinued, following AUTO-RE-
TURN of the tonearm.
3
REPEAT
When a wrong disc size has been selected
'Immediately depress the switch corresponding to
the proper size. This will cause the tonearm to be
transported to the position of the newly selected
disc-size to start play. Another method to correct
the mistake is to depress the CUT switch first and
then depress the proper disc-size switch.
" If, for example, a 17 cm disc is placed on the
platter but the 30 cm disc-size switch has been
depressed by mistake, it will cause damage to
the cartridge and stylus tip. So be extremely
careful not to misoperate the size switches.
SS R ONO
When you wish to skip a portion of music
1. Depress the UP switch of the ARM CONTROL.
The tonearm will rise,
2. Depress either the LEFTWARD FEED, or
RIGHTWARD FEED switch to move the tone-
arm to the desired position. The speed of the
tonearm movement can be controlled in two
steps. This permits fine regulation of the stylus
descending position.
3. Depression of the DOWN switch will cause the
tonearm to descend, initiating disc play. On
completion of the music, the tonearm will
return automatically to complete operation.
" When the ARM CONTROL switch is depressed
during disc AUTO-PLAY, will be released, and
REPEAT-PLAY will be released at the same time
if it has been selected.
Tonearm moves quickly. Tonearm moves slowly.
Fig. 16
10