Kenwood CK 307 Series Manual page 36

IGNITION OF THE OVEN BURNER
ATTENTION: Never turn the control
knob before opening the oven door.
To ignite the oven burner:
1. Open the oven door to the full extent.

WARNING: Risk of explosion! The
oven door must be open during this
operation.
2. Lightly press and turn the thermostat
knob anti-clockwise
maximum position Max
Press the knob firmly until the burner
lights.

In the case of a mains failure, to light
the oven burner manually, approach
a flame to the hole 'A' of the oven
floor (fig. 4.3). Never turn the gas
thermostat before approaching a
flame to the hole "A" of the floor.
Never continue this operation for
3.
more than 15 seconds. If the burner
has still not ignited, wait for about
1 minute prior to repeating the
ignition.
4. After lighting the burner, wait a few
seconds before releasing the knob
(until the safety valve stays open).
5. Close the oven door slowly and adjust
the burner according to the power
required.
If the flame extinguishes for any reason,
the safety valve will automatically shut off
the gas supply to the burner.
To re-light the burner, first turn the oven
control knob to position
least 1 minute and then repeat the lighting
procedure.
36 36
(fig. 4.2) to
(fig. 4.1).
0
, wait for at
A
For correct use of the gas oven, always
preheat it (bottom burner) at maximum
setting for at
Preheating should always be carried
out with the oven empty: remove the
trays and racks from the oven cavity.
OVEN COOKING
To cook, before introducing the food, preheat
the oven to the desired temperature.
When the oven has reached the desired
temperature, introduce the food, control
the cooking time and turn off the oven
5 minutes before the theoretical time to
recuperate the stored heat.
Fig. 4.2
least 15 minutes.
Fig. 4.3