Kenwood CK305-1 Instructions For Use Manual
  1. Manuals
  2. Brands
  3. Kenwood Manuals
  4. Cookers
  5. CK305-1
  6. Instructions for use manual
Kenwood CK305-1 Instructions For Use Manual

Kenwood CK305-1 Instructions For Use Manual

Dual fuel cooker
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
DUAL FUEL COOKER
CK305-1
model
Instructions for use - Installation advice
GB
Before operating this cooker,
please read these instructions carefully
1

Advertisement

Table of Contents
loading

Related Manuals for Kenwood CK305-1

Summary of Contents for Kenwood CK305-1

  • Page 1 DUAL FUEL COOKER CK305-1 model Instructions for use - Installation advice Before operating this cooker, please read these instructions carefully...

  • Page 2: Table Of Contents

    CONTENTS Page Number Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Important Safeguards &...

  • Page 3: Introduction

    Dear Customer, Thank you for purchasing a Kenwood CK305-1 dual fuel cooker. The safety precautions and recommendations reported below are for your own safety and that of others. They will also provide a means by which to make full use of the features offered by your appliance.

  • Page 4: Important Safeguards & Recommendations

    IMPORTANT SAFETY PRECAUTIONS AND RECOMMENDATIONS IMPORTANT: This appliance is designed and manufactured solely for the cooking of domestic (household) food and is not suitable for any non domestic application and therefore should not be used in a commercial environment. The appliance guarantee will be void if the appliance is used within a non domestic environment i.e.
  • Page 5 • Do not touch the appliance with wet or damp hands (or feet) . • Do not use the appliance whilst in bare feet . • If you should decide not to use this appliance any longer (or decide to substitute another model), before disposing of it, it is recommended that it be made inoperative in an appropriate manner in accordance to health and environmental protection regulations, ensuring in particular...
  • Page 6 • WARNING: Danger of fire: do not store items on the cooking surfaces. • WARNING: When correctly installed, your product meets all safety requirements laid down for this type of product category . However special care should be taken around the rear or the underneath of the appliance as these areas are not designed or intended to be touched and may contain sharp or rough edges, that may cause injury .
  • Page 7 ENERGY LABELLING/ECODESIGN • Commission delegated regulation (EU) No 65/2014 (supplementing Directive 2010/30/EU of the European Parliament and of the Council) . • Commission regulation (EU) No 66/2014 (implementing Directive 2009/125/EC of the European Parliament and of the Council) . Reference to the measurement and calculation methods used to establish compliance with the above requirements: •...

  • Page 8: Cooking Hob

    1 - COOKING HOB Fig . 1 .1 GAS BURNERS Auxiliary burner (A) 1,00 kW Semi-rapid burner (SR) 1,75 kW Rapid burner (R) 3,00 kW Triple-ring burner (TR) 3,50 kW Notes: • The electric ignition is incorporated in the knobs . •...

  • Page 9: Control Panel

    2 - CONTROL PANEL Fig . 2 .1 CONTROL PANEL - Controls description Front right burner control knob Rear right burner control knob Central burner control knob Rear left burner control knob Front left burner control knob Fan oven temperature control knob Fan oven function selector control knob 120 minutes timer control knob Fan oven temperature indicator light...

  • Page 10: Use Of Hob Burners

    3 - USE OF THE HOB BURNERS GAS BURNERS Gas flow to the burners is adjusted by turning the knobs (illustrated in fig. 3.1) which control the safety valves . Turning the knob, so that the indicator line points to the symbols printed on the panel, achieves the following functions: - symbol closed valve...
  • Page 11 LIGHTING THE BURNERS CHOICE OF THE BURNER ignite burner, following On the control panel, near every knob instructions are to be followed: there is a diagram that indicates which burner is controlled by that knob . Press in the corresponding knob and The suitable burner must be chosen turn counter-clockwise (fig.
  • Page 12 CORRECT USE OF THE TRIPLE-RING BURNER Only flat bottom pans of the correct size are to be placed on the pan support above the Triple-ring burner . When using a WOK, the supplied wok stand must be placed onto the pan stand to avoid any faulty operation of the triple-ring burner (fig.

  • Page 13: Fan Oven

    4 - FAN OVEN OPERATING PRINCIPLES Attention: the oven door becomes very hot during operation. Heating and cooking in the FAN oven are Keep children away. obtained in the following ways: GENERAL FEATURES a. by forced convection A fan sucks in the air contained in the With your new Fan oven it is possible to oven muffle, which sends it through cook a variety of food using the 2 different...
  • Page 14 TEMPERATURE KNOB (fig. 4.2) To turn on the heating elements of the oven, set first the function selector to the required setting and then the thermostat knob to the desired temperature . To set the temperature, line up the temperature knob indicator with the required temperature .

  • Page 15: Oven Temperature Guide

    5 - OVEN TEMPERATURE GUIDE Electric oven temperature Cooking process Oven heat Gas mark °C °F Keeping food hot, ½ very cool milk puddings Egg custards cool Rich fruit cakes, cool braising Low temperature moderate roasting, shortbread Victoria sandwich, plain fruit cake, moderate baked fish Small cakes, choux...

  • Page 16: 120 Minutes Timer

    6 - 120 MINUTE TIMER 120 MINUTE TIMER (fig. 6.1) The timer can be set to a maximum of 120 minutes and a buzzer will sound at the end of the countdown . The knob must be rotated clockwise as far as the 120 minute position first and then set to the required time by rotating it anticlockwise .

  • Page 17: Cleaning & Maintenance

    7 - CLEANING AND MAINTENANCE GENERAL ADVICE CLEANING • Before you begin cleaning, you • Stainless steel hob: Spillage on must ensure that the appliance is the hob can usually be removed by switched off at the cooker switch. a damp soapy cloth . More obstinate •...
  • Page 18 BURNERS AND PAN SUPPORTS • Inside of oven: The oven should always be cleaned after use when it These parts can be removed and cleaned has cooled down . The cavity should be as indicated previously . cleaned using a mild detergent solution After cleaning, the burners and their flame and warm water .
  • Page 19 Fig. 7.1 Fig. 7.2 Fig. 7.3 Fig. 7.5 Fig. 7.4...
  • Page 20 ASSEMBLY AND DISMANTLING OF Fig. 7.6 THE SIDE RUNNER FRAMES • Fit the side runner frames into the holes on the side walls inside the oven (fig. 7.6). • Slide the rack into the runners (fig. 7 .7) . The rack must be fitted so that the safety notch, which stops it sliding out, faces the inside of the oven;...
  • Page 21 Fig . 7 .9 Fig . 7 .10 OVEN DOORS STORAGE COMPARTMENT The internal glass panel can be easily The storage compartment is accessible removed for cleaning by unscrewing the through the pivoting panel (fig. 7.10). retaining screws (fig. 7.9). Do not use harsh abrasive cleaners or Do not store flammable material in the sharp metal scrapers to clean the oven...
  • Page 22 REPLACING THE OVEN LAMP WARNING: Ensure the appliance is switched off and disconnected from the electrical power supply before replacing the lamp to avoid the possibility of electric shock. • Let the oven cavity and the heating elements to cool down . •...
  • Page 23 REMOVING THE OVEN DOOR The oven door can easily be removed as follows: • Open the door to the full extent (fig. 7 .12a) . • Open the lever “A” completely on the left and right hinges (fig. 7.12b). • Hold the door as shown in fig.

  • Page 24: Advice For The Installer

    Advice for the installer IMPORTANT • The appliance is designed and approved for domestic use only and should not be installed in a commercial, semi commercial or communal environment . Your product will not be guaranteed if installed in any of the above environments and could affect any third party or public liability insurances you may have.

  • Page 25: Installation

    8 - INSTALLATION This cooker has class “2/1” overheating protection so that it can be installed next to a cabinet. If the cooker is installed adjacent to furniture which is higher than the gas hob cooktop, a gap of at least 200 mm must be left between the side of the cooker and the furniture . The walls and kitchen furniture surrounding the appliance must be made of non-flammable material .
  • Page 26 FITTING THE ADJUSTABLE FEET AND LEVELLING THE COOKER The adjustable feet must be fitted to the base of the cooker before use (figs. 8.2, 8 .3) . Rest the rear of the cooker on a piece of the polystyrene packaging exposing the base for the fitting of the feet.
  • Page 27 MOVING THE COOKER WARNING: When raising cooker to upright position always ensure two people carry out this manoeuvre to prevent damage to the adjustable feet (fig. 8.5). Fig. 8.5 WARNING WARNING Be carefull: Do not lift the cooker by When moving cooker to its final position the door handle/s when raising to the DO NOT DRAG (fig. 8.7). upright position (fig. 8.6). Lift feet clear of floor (fig. 8.5). Fig. 8.7 Fig.
  • Page 28 ANTI-TILT BRACKET Important! To restrain the appliance and prevent it tipping accidentally, fit a bracket to its rear to fix it securely to the wall. To fit the anti-tilt bracket: After you have located where the cooker is to be positioned, mark on the wall the place where the two screws of the anti-tilt bracket have to be fitted. Please follow the indications given in fig. 8.8. Drill two 8 mm diameter holes in the wall and insert the plastic plugs supplied .
  • Page 29 PROVISION FOR VENTILATION • The appliance should be installed into a room or space with an air supply in accordance with the current version of BS 5440-2: 2000 . • For rooms with a volume of less than 5m - permanent ventilation of 100 cm free area must be provided .

  • Page 30: Gas Installation

    9 - GAS INSTALLATION IMPORTANT NOTE This appliance is supplied for use on NATURAL GAS or LPG (check the gas regulation label attached on the appliance) . • Appliances supplied for use on NATURAL GAS are adjusted for this gas only and cannot be used on any other gas (LPG) without modification.
  • Page 31 RESTRAINING CHAIN Fig. 9.1 Chain security holes Cooker Back of the cooker Rear wall Installation to Natural Gas Installation to Natural Gas must conform to the Code of Practice, etc . The supply pressure for Natural Gas is 20 mbar . The installation must conform to the relevant British/European Standards .
  • Page 32 Notes: • Flexible hoses can be used where the sited ambient temperature of the hose does not exceed 70°C. These hoses must be manufactured in accordance with BS669 part 1 or EN 14800 and be of the correct construction for the type of gas being used.
  • Page 33 Fitting the plug Fig. 9.3 on the inlet pipe terminal not used Cooker manifold (right Cooker or left inlet pipe) manifold (right or left inlet pipe) Manifold male Manifold pipe fitting male 1/2” G cylindrical pipe fitting (ISO 228-1) male 1/2”...
  • Page 34 CONVERSION TO NATURAL GAS OR TO LPG REPLACEMENT OF THE INJECTORS Auxiliary, If the injectors are not supplied they can Semi-rapid and be obtained from the After-Sales Service. Rapid burners Select the injectors to be replaced according to the “Table for the choice of the injectors”...
  • Page 35 TABLE FOR THE CHOICE OF THE INJECTORS Cat: 2H3+ Natural Gas G30 28-30 mbar G20 20 mbar Nominal Reduced G31 37 mbar BURNERS power power [kW] [kW] Ø Ø injector injector [1/100 mm] [1/100 mm] Auxiliary (A) 1,00 0,30 Semi-rapid (SR) 1,75 0,45 Rapid (R)

  • Page 36: Electrical Section

    10 - ELECTRICAL INSTALLATION IMPORTANT: The appliance must be installed in accordance with the manufacturer’s instructions. Incorrect installation, for which the manufacturer accepts no responsibility, may cause damage to persons, animals and property. The connection of the appliance to earth is mandatory. The manufacturer declines all responsibility for any inconvenience resulting from the inobservance of this condition.
  • Page 37 ELECTRICAL FEEDER CABLE CONNECTION WARNING: If the power supply cable is damaged, it must be replaced only by an authorised service agent in order to avoid a hazard. To connect the supply cable: • Remove the screw securing the cover “A” on the rear of the cooker (fig. 10.2). •...
  • Page 38 11 - GUARANTEE Your new “KENWOOD” product comes with 12-month guarantee covering all parts and labour . If your appliance proves to be defective as a result of faulty materials or workmanship during the guarantee period, these parts will be repaired or replaced free of charge .
  • Page 40 The manufacturer cannot be held responsible for possible inaccuracies due to printing or transcription errors in the present booklet . The manufacturer reserves the right to make all modifications to its products deemed necessary for manufacture or commercial reasons at any moment and without prior notice, without jeopardising the essential functional and safety characteristics of the appliances .

Table of Contents