Table of Contents
Advertisement
Fine tuning of the position
(Fader/Balance)
After choosing the position using the
position selector function, it is possible to
32
. Press button [4] to switch to the position
fine tuning mode.
2
Press (A) or (W) side of buttons [6]
to adjust the volume balance between
the front and rear (fader control).
(Numeric display [17] shows "F25 —
R25".)
3 Basses
sess
aie ieiuteaael
= Fe c
. Press (<4) or () side of buttons [5] to
adjust the balance between the left and
right (balance control).
(Numeric display [17] shows "L25 —
R25".)
. Press button [11] to quit the position
fine tuning mode.
Resetting the Position
The sound image positioning after fine
tuning can be reset to the initial conditions
of the fader and balance control.
Press and hold button [7] for more than 2
seconds.
A short beep sound is generated and the
fader/balance are initialized.
-
Only the currently selected position can
be reset.
Note:
.
The fader control is not used with
a 2-speaker system. Set the fader to the
center position.
Advertisement
Table of Contents
