Yamaha FLIP-X Series Maintenance Manual page 84

9 Pull out the pulley from the motor.
Remove the bolts (M6) (4) securing the
pulley fastening boss and pull out the pulley
from the motor.
Loosen the bolts while securing the
machined surface of the boss with pliers.
0 Replace the motor with a new one
and attach the pulley to this new
motor.
Take care to the orientation and order of
the rings at this time.
q Install the motor onto the block.
Temporarily tighten the mounting bolts.
4
w Install the belt.
Adjust the belt tension while referring to
"3 Adjusting the timing belt tension (F20N)" in
Chapter 3.
Reattach the motor cover and belt
e
cover.
r Reattach the cover.
Connect the motor cable connectors, store
the cables in the wiring box, and reattach
the cover.
4-10
Step 9
Removing the mounting bolts
53404-A9-00
53405-A9-00
Step 10
Attaching the pulley
53406-A9-00
Step 11
Installing the motor
4-M6
Hexagon bolt
38
Ring
Pulley
Motor
Boss