Advertisement
Specifications
WM (Wave Memory) and FM (Frequency Modulation); Upper: 8-note polyphonic; Lower:
8-note polyphonic; Pedals: monophonic
Tone Generator
Ensemble
Upper, Lower, Pedals
Footsw.; Reverb On/Off, Depth; Pitch; Transposition
Registration Memory
|16 Memories x 4 Banks; 16 Preset Combinations
HE Electones; optional), 2-unit Bracket BRT-3D (for HX, HS and HE Electones; optional),
Power Adaptor PA-W10 (DC In 10V; 700mA - A; not included)
Dimensions (W x D x H) | 135 x 200 x 63.5mm (5.3" x 7.9" x 2.5")
Weight
1.1kg (2.4 lbs.)
"Specifications and descriptions in this User's Guide are for information purposes only. Yamaha Corp. reserves the right to change or modify products
or specifications at any time without prior notice. As specifications, equipment or options may not be the same in every locale, please check with
Yamaha dealer.
CANADA
IN RADIO INTERFERENCE REGULATIONS.
*This applies only to products distributed by Yamaha Canada Music Ltd.
FCC Information (USA)
While the following statements are provided to comply with FCC
Regulations in the United States, the corrective measures listed are
applicable worldwide.
The digital series of Yamaha Electones™ use frequencies that appear
in the radio frequency range, and if installed in the immediate
proximity of some types of audio or video devices within three meters
(approximately ten feet), interference may occur.
This series of Yamaha Electones™ has been type-tested and found to
comply with the specifications set for a class B computer in accordance
with those specifications listed in sub-part J, part 15 of the FCC rules.
These rules are designed to provide a reasonable measure of
protection against such interference.
However,
this does not
guarantee that interference will not occur.
If your Electone™ should be suspected of causing interference with
other electronic devices, verification can be made by turning your
Electone™ off and on. If the interference continues when your
Electone™ is off, the Electone™ is not the source of the interference.
If your Electone™ does appear to be the source of the interference,
you should try to correct the situation by using one or more of the
following measures:
@ Relocate either the Electone™ or the electronic device that is being
affected by the interference.
@Utilize power outlets for the Electone™ and the device being
affected that are on different branch (circuit breaker or fuse) circuits,
or install AC line filters.
@Jn the case of radio-TV interference, relocate the antenna or if the
antenna lead-in is 300 ohm ribbon lead, change the lead-in to coaxial
type cable.
If these corrective measures do not produce satisfactory results, please
contact an authorized Yamaha Electone™ dealer for suggestions
and/or corrective measures. If you can not locate an authorized
Yamaha Electone™ dealer in your general area, please contact the
Electone™ Service Department, YAMAHA
CORPORATION
OF
AMERICA, U.S.A., 6600 Orangethorpe Ave., Buena Park, CA 90620.
If for any reason, you should need additional information relating to
radio or TV interference, you may find a booklet prepared by the
Federal Communications Commission Helpful: "How to Identify and
Resolve Radio-TV Interference Problems." This booklet, Stock
#004-000-00345-4, is available from the US. Government Printing
Office, Washington DC. 20402.
Advertisement
