Table of Contents
Advertisement
■
Change of the transfer current setting (Only for Japanese hagaki printing)
<Function>
Dots appeared when hagaki printing is performed can be alleviated by changing the transfer
current setting.
<Operating procedure>
Model without touch panel
(1) Press the
"MAINTENANCE 45" on the LCD in the
initial state of the maintenance mode.
Then, press the OK key. "USBNo." is
displayed on the LCD.
(2) Press the
"Special Printing" and then press the
OK or Go key. "default" is displayed on
the LCD.
(3) Press the
setting, and press the OK or Go key.
There are four setting options: "default",
"HAGAKI1", "HAGAKI2", and
"HAGAKI3". ("*" is displayed at the end
of the currently specified function in the
LCD display. The initial value is
"default".)
(4) "Accepted" is displayed on the LCD,
and the machine returns to the initial
state of the maintenance mode.
(5) Perform hagaki printing again to check
if the dot symptom is alleviated.
(6) If not, repeat the steps (1) to (4) to set
an optimum option, and then perform
hagaki printing.
or
key to display
or
key to display
or
key to change the
5-27
Model with touch panel
(1) Press the 4 and 5 keys in this order in
the initial state of the maintenance
mode. "USBNo." is displayed on the
LCD.
(2) Press the
or
"Special Printing" and then press the
Mono or SET key. "default" is displayed
on the LCD.
(3) Press the
or
setting, and press the Mono or SET
key. There are four setting options:
"default", "HAGAKI1", "HAGAKI2", and
"HAGAKI3". ("*" is displayed at the end
of the currently specified function in the
LCD display. The initial value is
"default".)
(4) "Accepted" is displayed on the LCD,
and the machine returns to the initial
state of the maintenance mode.
(5) Perform hagaki printing again to check
if the dot symptom is alleviated.
(6) If not, repeat the steps (1) to (4) to set
an optimum option, and then perform
hagaki printing.
key to display
key to change the
Confidential
Advertisement
Table of Contents
Troubleshooting
