Electrolux SkyLine PremiumS User Manual page 73

Anom- Type of
Description
aly anomaly
EtC Stops the Cavity safety thermo-
oven stat trips.
N°210
Overtemperature in
the cavity
EtUb Stops Boiler overtemperature
boiler
N°221
cycles
EtUC Stops the Cavity
oven overtemperature
N°211
FA8H After Oven worked 8 hours
ending without air inlet filter
N°324
cooking
cycle,
stops oven
cooking
FCLn Stops next Forced Cleaning
cooking
cycle
FCt Stops oven
FDXX Stops oven Lower cavity motor
(XX = 00 failure
- 17)
FLA1 Stops The FLASH EPROM
oven; fatal ID is different as
N°102
error expected
FLA2 Stops Communication chan-
oven; fatal nel between FRAM
N°103
error and microcontroller is
malfunctioning or
blocked
FLEE Stops oven SPI-FLASH memory
block erase error (4kb
N°142
block)
FLrE Stops oven SPI-FLASH memory
reading error
N°140
Possible causes
• The cavity is dirty;
• The parameter COT is
set too high;
• The safety thermostat
bulb or the capillary are
damaged;
• The motor fan is blocked
while the heat is still On;
• The temperature TC
sensor provides erratic
measurements
• Leakage of heat in the
safety thermostat body
area.
• Room temperature <5°C.
• Missing water in the
boiler (electric heated
appliances only);
• Limestone accumulation
in the boiler;
• The parameter BOT is
set too low.
• The cavity is dirty;
• The parameter COT is
set too low.
Misuse
Maximum cooking time
elapsed from last automatic
cleaning cycle.
The User Interface is not
programmed with the
software
Diagnostic according to
error number (from 00 to 17)
displayed.
Actions
Manually clean the oven cavity and call Service.
• Wait for the boiler temperature to cool down
(alarm ETUB will disappear)
• Run a cleaning program including the rinse
and descale cycle and use the quantity of C25
tabs indicated in F.16.2 BOILER DESCALING
procedure of this Manual):
• In case the alarm re-appears, descale the
boiler again.
• If the problem persists, call Service.
• Launch a cooling cycle; if not possible open
the door and let the oven to cool down; clean
the cavity.
• When the temperature drops it is possible to
launch a new cooking cycle.
• If the error shows up again call Service.
Restore the air inlet filter checking its cleanness
before fitting it back in place. In case the filter is
lost, call Service
Run an automatic cleaning cycle.
Call Service.
Switch the oven OFF/ON;
If the error persists, manually clean the oven
cavity and call Service.
Communication impossible with external SPI-
FLASH memory.
• Switch OFF and ON the oven, if the problem
persists, call Service.
Unknown SPI-FLASH memory device.
• Switch OFF and ON the oven, if the problem
persists, call Service.
Error during SPI-FLASH memory block erase.
• Switch OFF and ON the oven, if the problem
persists, call Service.
Error during SPI-FLASH memory reading.
• Switch OFF and ON the oven, if the problem
persists, call Service.
73