Electrolux SkyLine PremiumS User Manual page 25

How to use a probe
1. Touch the time and select the CORE PROBE option;
MANUAL
1
70
%
2
230
°C
00:30
:00
Pasteurization factor (if activated)
F
Touch "F" to insert the factor value to be reached by the
end of the cooking cycle.
2. Select the most appropriate probe and enter the core probe
temperature on the numeric keypad (e.g. 55 ℃).
70
°C
1 2 3
4 5 6
7 8 9
0
3. Touch button to start the cycle.
Wait until the display indicates that the preheating (or
precooling) phase is finished.
4. Open the door, insert the food into the cavity;
WARNING
Risk of burns. Always open the
door with caution when the
oven is hot.
5. Remove the core probe from its seat and insert it in the
product without forcing excessively;
Make sure the tip (the sensitive part) is positioned near the
centre of the product.
It is important to place the core probe correctly near the
centre of the product, making sure the tip does not protrude
and, in particular, that it does not to touch the pan.
MANUAL
1 2 3
4 5 6
7 8 9
F 0
1
70
%
230
°C
55
°C
IMPORTANT
The core probe is a precision component. Absolutely
avoid impacts, forcing when inserting, and pulling of
the flexible cable (in particular when using the trolley-
mounted structures).
The warranty does not cover the replacement of core
probes damaged by improper use.
6. Close the oven door.
The PROBE cycle keeps running.
End Probe cycle
• When the required product core temperature is reached the
oven stops automatically. The display shows the duration of
cooking cycle;
Probe cycle deactivation
• To deactivate the PROBE cycle just press the TIME button
and set a cooking time. This action automatically cuts out the
core probe and viceversa.
When the oven is switched off the core probe option is also
deactivated.
NOTE!
With vacuum packed food products it is necessary to
use the special external core probe (accessory
available on request), to be connected to the USB
pendrive. For its use, see the instructions included
with the accessory.
USB probe
If you set a cycle with the USB probe and the probe is
disconnected from the appropriate port, after the preheating the
25