NEC Express5800/320Fa-L User Manual page 323

Did you install drivers for connected optional devices?
→ Some optional devices require specific device drivers. Refer to the manual that
comes with the device to install its driver.
Is SCSI controller (including options) configuration correct?
→ If the sever has an optional SCSI controller board and SCSI devices are hooked up
to the server, make correct settings by the SCSI controller board's SCSI BIOS
utility. For details, see manuals included with the SCSI controller board.
Is SCSI device configuration correct?
→ If external SCSI devices are connected to the server, you need to make settings of
SCSI ID and terminal resistance. For details, see manuals included with the SCSI
device.
CPUs not in Duplex mode:
→ Check if the memory configuration is correct.
→ Check if third-party CPUs or memory (DIMM) are used.
Disks not in Duplex mode:
→ Unless you perform mirroring (including reconfiguration after failed disks are
replaced) in correct order, the mirror may not be (re)configured. Check if the steps
were correct.
The keyboard or mouse fails to operate:
Is the cable properly connected?
→ Make sure that the cable is connected to the correct connector on the rear of the
server.
Are the keyboard and mouse are compliant with NEC Express5800/ft series?
→ Operation of the server with unauthorized devices is not guaranteed.
Does the server have drivers installed?
→ Refer to the manual that comes with your OS to check that the keyboard and
mouse drivers are installed. (These drivers are installed along with the OS.) Some
OS's allow you to change the keyboard and mouse settings. Refer to manual that
comes with your OS to check that the keyboard and mouse settings are correct.
Troubleshooting 7-17