Table of Contents
Advertisement
Chapter 3 Setup
2.
BIOS Setup Utility (SETUP)
This section describes how to configure Basic Input Output System (BIOS).
2.1
Overview
BIOS Setup Utility (SETUP) is a utility to configure basic hardware settings. This utility is installed in the server
as standard.
Factory settings of BIOS are set with optimal values. Usually, you do not need to run SETUP. Modify the
settings only at the cases described in Chapter 3 (2.4 Cases that Require Changes).
2.2
Starting and Exiting SETUP
2.2.1
Starting SETUP
Run POST following Chapter 3 (1.1.1 POST sequence).
After a while, the following message will be displayed on the lower left of the screen. (The on-screen
message varies depending on the environment.)
Press <F2> SETUP, <F4> ROM Utility, <F12> Network
If you press <F2> key, SETUP starts upon completion of POST, and the Main menu appears .
If you have set a password, the following message appears and prompts you to enter the password.
Enter Password [
If you enter incorrect password consecutively three times, the operation stops and you cannot proceed. Turn
off the power, and try again.
2.2.2
Exiting SETUP
To exit SETUP after saving changes, choose Save & Exit Save Changes and Exit.
To exit SETUP without saving changes, choose Save & Exit Discard Changes and Exit.
Tips
In Legacy boot mode, you can also launch SETUP by pressing the <F2> key while
expanding option ROM.
]
Tips
If you wish to restore the setting to default values, select Save & Exit and then
Load Setup Defaults. (The default value might be different from the factory
setting.)
You cannot restore the default value in the following submenus in Advanced
menu:
– iSCSI Configuration submenu
– UEFI Driver Configuration submenu
Express5800/T110i-S User's Guide
2. BIOS Setup Utility (SETUP)
113
Advertisement
Table of Contents
