The "Utility For In-Wall Unit Setup Menu" Window For Each Unit - Sony DVP-NW50 User Manual

Setup 3: Setting up the Utility for In-Wall Unit software (continued)

The "Utility for In-Wall Unit Setup Menu" window for each unit

1 Unit Name
You can enter a name of up to eight characters for each
Unit.
2 IP Address
Static: You must enter an IP address manually.
Auto: An IP address is acquired automatically.
Tip
To use "Auto" to automatically acquire an IP address, a DHCP
server must be available on the network. Most broadband
routers can act as DHCP servers. Refer to the manual that
supplied with your router for more information.
3 Clock
You can adjust the time of the selected Unit by entering
a new time.
4 Party Privacy
ON: The selected Unit does not join Party Mode.
OFF: The selected Unit joins Party Mode automatically.
5 Intercom Privacy
ON: The selected Unit ignore the Intercom signal.
OFF: The selected Unit can receive the Intercom
signal.
Click to select the ring tone.
6 Monitor Privacy
ON: The selected Unit cannot be monitored by other
Units.
OFF: The selected Unit can be monitored by other
Units.
7 Volume Preset
ON: The selected Unit plays sound at the selected
volume level.
OFF: The preset volume level is disabled.
The selected Unit plays sound at whatever volume
level was set when the Unit was last turned off.
8 Tuner Preset
Click "FM/AM Preset" to configure the selected Unit
with up to 20 FM or AM radio stations. For details on
how to storing FM/AM radio stations, see page 13.
9 Line in Name
You can enter a name for an audio component
connected to the LINE IN of the selected Unit.
Continue to the next page l
Chapter 1
12
Getting Started