Table of Contents
Advertisement
1. Fuel tank cap
4. Add unleaded gasoline to the fuel tank, until the level is
1/4 to 1/2 inch below the bottom of the filler neck.
Important: This space in the tank allows gasoline
to expand. Do not fill the fuel tank completely full.
5. Install the fuel tank cap securely.
6. Wipe up any gasoline that may have spilled.
Checking the Engine-Oil Level
Service Interval: Before each use or daily
1. Park the machine on a level surface, lower the grinder,
and stop the engine.
2. Remove the key and allow the engine to cool.
3. Clean around the oil dipstick (Figure 17).
1. Oil filler hole
2. Oil dipstick
4. Remove the dipstick and wipe the end clean (Figure 17).
Figure 16
Figure 17
3. Full mark
4. Add mark
5. Slide the dipstick fully into the dipstick tube without
threading it into the filler neck (Figure 17).
6. Pull the dipstick out and look at the end. The oil
should be between the Add and Full marks (Figure 17).
7. If the oil is below the Add mark, add 10w30 engine oil
to the filler hole, checking the level frequently with the
dipstick, until the oil level reaches the Full mark.
8. Replace the dipstick.
Checking the Hydraulic-Fluid
Level
Service Interval: Every 25 hours
Hydraulic Tank Capacity: 23 L (6 US gallons)
Refer to Changing the Hydraulic Fluid (page 35) for
hydraulic-fluid specifications.
1. Park the machine on a level surface and lower the
grinder.
2. Stop the engine, remove the key, and allow the engine
to cool.
3. Look into the glass bubble on the right side of the
machine; if you cannot see hydraulic fluid in the bubble,
continue this procedure to add fluid.
1. Hydraulic-fluid check-bubble
4. Remove the cover plate; refer to Removing the Cover
Plate (page 22).
5. Clean the area around the filler neck of the hydraulic
tank and remove the cap and filter from the filler neck
using a socket (Figure 19).
16
Figure 18
Advertisement
Table of Contents
