Table of Contents
Advertisement
Figure 56
1. Hose
2. Hydraulic tank fitting
3. Hose clamp
9. When finished, install the hose onto the fitting and
secure it with the hose clamp.
Note: Dispose of the used oil at a certified recycling
center.
10. Fill the hydraulic tank with approximately 23 L (6 US
gallons) of hydraulic fluid as specified previously.
11. Add 236 ml (8 fl oz) of AMSOIL
differential additive or an equivalent differential
additive to the hydraulic tank.
Note: AMSOIL and Slip-Lock are trademarks of
AMSOIL Inc.
12. Install the hydraulic filter and filler cap (Figure 55) and
torque bolt on top to 13 to 15.5 N-m (110 to 140 in-lb).
13. Start the engine and let it run for a few minutes.
14. Stop the engine.
15. Check the hydraulic fluid level and top it off if
necessary; refer to Checking the Hydraulic-Fluid Level
(page 16).
16. Clean up any spilled fluid.
17. Install the top cover.
Checking the Hydraulic Lines
Service Interval: Every 100 hours—Check the hydraulic
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury. Fluid injected into
the skin must be surgically removed within a few
hours by a doctor familiar with this form of injury
or gangrene may result.
®
Slip-Lock™
36
lines for leaks, loose fittings, kinked lines,
loose mounting supports, wear, weather,
and chemical deterioration and repair if
necessary.
Every 1,500 hours/Every 2 years (whichever comes
first)—Replace all moving hydraulic hoses.
WARNING
• Keep your body and hands away from pin
hole leaks or nozzles that eject high pressure
hydraulic fluid.
• Use cardboard or paper to find hydraulic leaks,
never use your hands.
Advertisement
Table of Contents
