Toshiba GN-1040 Operator's Manual page 26

1. Setting Up Wireless Network
6.
NOTE: The encryption intensity between each encryption is:
AES(CCMP) > TKIP > Dynamic WEP
7.
26
ENCRYPTION INTENSITY
Select the encryption intensity. When the PEAP protocol is selected, only [LOW]
can be selected.
Specify the following items and press the [NEXT] button.
ENCRYPTION BETWEEN AP AND STA.
Select the encryption type that is used for the communication between Access
Point and this equipment.
[TKIP] — Select this to use TKIP encryption. The TKIP provides a different key
for per packet with a message integrity check. This key will be changed for
every fixed interval.
[AES(CCMP)] — Select this to use AES encryption. The AES is the next-
generation cryptography algorithm that the U.S. government improves to replace
the DES and 3DES.
[Dynamic WEP] — Select this to use Dynamic WEP encryption. The Dynamic
WEP provides the encryption using WEP technology and it allows the WEP key
to change dynamically for every fixed interval. The Dynamic WEP does not
support the PEER KEY for IEEE802.1x.
Specify the following items and press the [NEXT] button.
TRANSMIT POWER
Select the low transmit power if you want to limit the area that the wireless
communication is enabled. If you do not have to limit the area, select [100%].
TRANSMIT RATE
Select the transmit data capacity for wireless communication. If you do not have
to specify the fixed rate, select [AUTO]. When [AUTO] is selected, this
equipment will use appropriate rate depending on the condition.
Generally select [AUTO]. The communication may fail unexpectedly if you
select a static transmit rate.
GN-1040 Operator's Manual — Setting Up the Infrastructure Mode